composite sheet cleaning and Maintenance Guide

It is not recommended that the aluminum sheets of the premium bond composite be cleaned regularly.

These sheets can be cleaned with a weak solution of water and detergent and then cleaned with clean water.

Intermittent cleaning and selection of service agencies for cleaning depends on the location of the building and the degree of contamination of the plates.

Never clean sunscreens (above 40 degrees)
Because rapid drying at high temperatures causes the plates to stain.

Cleaning should be done with clean water.

In this way, first remove all contaminants with water and then clean the screen from top to bottom with a sponge.
Finally, dry the plate with a sponge or a damp cloth so that no water remains on it.

The premium aluminum composite sheet is very resistant to air pressure
And in many environments it is automatic and without the need for cleaning.

For better durability of this product, it is appropriate to clean the annual premium bond aluminum composite sheet with hot water in order to prevent the accumulation of sediment and contamination on the plates.

This product is anti-static and has more cleaning ability than similar products.

How do you clean Aluminium facade?

There are two main ways to clean a cladding system. For dry dirt such as dust from the air, rain spots, and cobwebs, take a soft bristle broom or brush and wipe the facade. This should remove most visible dirt. If you’re removing salt spray or droppings, it’s best to start with a dry wash

How do you maintain aluminum cladding?

A thorough clean water rinse should follow. Do not allow cleaning solutions or contaminated water to dry on the surface. Air or wipe dry with a soft, lint free, dry cloth. Note: Do not rinse glass or cladding with pressurized spray, such as from a pressure washer or direct garden hose.

Field of use

The tips for the process of Premium bond composite sheet cleaning and maintaining
the outer aluminum coating with varnish-kiln coating consisting
of fluorocarbon, polyester, pvdf and acrylic paint can be used.

The purpose of this section is to guide users of this product, such as architects, contractors, owners of complexes and buildings, etc., who are directly involved in the maintenance and maintenance of the building’s exterior, especially its installation and maintenance.