Aluminum composite and installation

Things to Know about Aluminum Composite Panels Installation

There are several ways to make Aluminum composite and installation .
One of the most important methods of installing a building facade is the rail method or HANGING.

This method is one of the best methods as well as the cheapest ways to install a building facade and is therefore popular.

Aluminum composite is one of the best and most special types of building facades.

The facade of the building, which is made of this material,
It has a special effect and it costs a lot.

That’s why many office buildings and even universities use this type of material to create facades.

There are several ways to install composite aluminum, one of which is the rail method.

This method has special features that are not seen in other methods of installing composite facade aluminum.

Hanging rail method

In this method, the sheets are installed on the special aluminum profiles by rail using embedded grooves. In this case, due to the lack of screws or rivets, the working speed is high, it is possible to separate and replace each of the parts separately, and also due to the use of aluminum stud profiles, there is no need to seal the facade.

In this method, after the implementation of iron belts to form the substructure, iron angles with the characteristic of bean holes are installed on the belts according to the oxidation provided in the executive plans.

In the next step, the aluminum rail studs with a fixed cross section in the iron angles are connected to the substructure by aluminum brackets with two bean holes. In this method, like the fixed aluminum method, to prevent corrosion between iron and aluminum, rubber between aluminum lamella and iron corner is used.

Composite sheets are installed on the studs by means of aluminum connections in the form of studs (stud studs) that are inside the aluminum lamellae. Showed.

Steps of implementation of infrastructure in rail method (Hanging)

• Performing bolt rolling and connecting 80 * 40 vertical and horizontal metal cane gloves
• Welding of metal cans
• Install metal brackets
• Installation of aluminum corners
• Installation of rail studs
• Install Bolt studs
• Groove and sheet cutting
• Bending and sheet assembly
• Installation and fixing of sheets

Of course, there are other methods, but this method, due to its advantages and benefits, has been and still is considered by the building facade installer.